Good to see you!
Or by email
Welcome to Dulux
Or by email
Terms and Conditions
Thanks for registering
We will sent you colourful news every now and then
Registration complete
Forgotten your password?
Please enter email address associated to your account
Password changed successfully
We successfully updated your personal details.
Forgotten your password?
Would you spare a minute to answer 3 questions
We will use this to provide you with useful information
Thanks for registering
We will send you colourful news every now and then
Dulux Aquatech Exterior PU Coat
Your Measurements:
Amount Needed:
For the best result we recommend to use
{coatAmount} for {productTitle}
-
Finish N/A
-
Coverage – upto 10 sqft/L for Horizontal Surfaces in 3 coats – upto 40 sqft/L for Vertical Surfaces in 1 coat
-
Drying Time 5-6 hours after each coat
-
Coats 1
-
Superior Waterproofing Performance of upto 15 years
-
Upto 4mm crackbridging
-
Surface Temperature reduction of upto 12 deg C
-
Multi-surface Adhesion
Product Description
Dulux Aquatech Exterior PU coat is a superior waterproofing technology with hybrid Acrylic-Polyurethane technology and is suitable for both horizontal and vertical wall application. Its thick, elastomeric super protective film covers cracks of upto 4mm and the strong network of reinforced polymers makes the coating extremely tough and dirt & water resistant.
Application Description
Clean the roof and parapet surface thoroughly as explained above. Apply a self-priming coat of Dulux Aquatech PU Coat over the dried surface by diluting with water up to 30% followed by 2-3 coats of Dulux Aquatech PU Coat without dilution using a brush or roller.
Apply the second coat of Dulux Aquatech PU Coat at 90° to the first coat application. Allow the surface to dry for 5-6 hours for each coat application.
Achieving a recommended DFT is very important for water proofing. Therefore, achieve a forced coverage of 8-10 Sqft/litre. If forced coverage is not achieved apply an additional coat of Dulux Aquatech PU Coat.
Apply the second coat of Dulux Aquatech PU Coat at 90° to the first coat application. Allow the surface to dry for 5-6 hours for each coat application.
Achieving a recommended DFT is very important for water proofing. Therefore, achieve a forced coverage of 8-10 Sqft/litre. If forced coverage is not achieved apply an additional coat of Dulux Aquatech PU Coat.
Health & Safety
– Treatments such as sanding, burning off etc. of paint films may generate hazardous dust and/or fumes.
– Wet sanding should be used whenever possible. Work in well ventilated areas.
–Keep out of reach of children.
–Refer Safety Data Sheet for more details.
Tips & Advice
-
1. CleaningClean painting equipment immediately after use and dry
-
2. StoringStore under cover, away from direct sunlight and protect from extreme temperatures
How much paint do I need?
More than one wall to paint? Try our advanced paint calculator
Measure the height and length of the surface you want to paint (in metres or centimetres).
Your Measurements:
{{!-- This value will be injected with JavaScript --}}
Amount needed:
{{!-- This value will be injected with JavaScript --}}
This is an estimated based on 2 coats. Actual coverage will depend on the conditions of the surface. If the colour change is strong, more coats may be required.
More than one wall to paint? Try our advanced paint calculator